All Products

Installation from Meter cabinet including additional material and labour

This charger to be fed from board in utility room in the middle of the house. 

Drill through wall into kitchen run in trunking along ceiling and out gable wall and down to plinth level. 

Run along plinth to charger location beside meter cabinet. 

additional 18 meters of SWA needed. 

This charger to be fed from board in utility room in the middle of the house. 

Drill through wall into kitchen run in trunking along ceiling and out gable wall and down to plinth level. 

Run along plinth to charger location beside meter cabinet. 

additional 18 meters of SWA needed. 

8 meters of SWA cable needed.

Customer has requested SWA cable to be run from DB to front of house around to Ev point at side of house.

Install needs 14 meters of swa cable.

Charger to be sourced from fuse board to right of front door. 

Drill out back of fuse board up and over arch drill out above plinth level . 

Run cable along plinth through wall and to the left to middle of gable wall where the charger is to be located. 

Charger is fitted in an area with shared parking behind gates, charger will need to be a socket unit.

Option 1-

This charger is to be fed from sub panel fed by 3x10 SWA cable. 

Drill out through back wall and into duct to be installed by customer- ducting to be done prior to installation.

Once through duct cable to run along wall at low level going around several pillars to charger location at garage. 

Cat 6 external cable will have to be run passed sub panel and clipped around to front of house and to be drilled in beside front door to meter location inside the front hall. 

35 meters of SWA cable will be needed . 

57meters of external cat 6 to reach main board at front of the house.